Deleting internal code changes

Delete internal code changes to allow retrieving the changes over again if errors occurred during previous attempts to retrieve, install, or activate the changes.

Delete retrieved internal code changes if an error occurred while retrieving them. Remove then delete installed internal code changes if an error occurred while installing or activating them.

Deleting internal code changes erases retrieved internal code changes and removed internal code changes from the support elements of the selected Central Processor Complexes (CPCs).

Important:

Refer to the instructions in the following example for general guidance. Then, while performing the task, request help for any window while it displays for more information about using it to complete the task.

Example 1

The following example shows the steps for deleting all internal code changes that are currently retrieved or removed.

From the Hardware Management Console Workplace:
1. Select the target CPCs or CPC group, and start the task: Change Internal Code.

   This opens the Change Internal Code window. From the Change Internal Code window:

2. Select Delete all retrieved changes that were not installed, then select OK.

   This opens the Confirm the Action window. From the Confirm the Action window:

3. Select Delete to begin the process.
4. Wait until a message indicates the process is complete, then select OK to close the message.

   This completes the task.